View non-flash version
W A NEW ALCAP SYSTEM SAVES $2 TO $5 PER TON OF FUEL. Until now, if you wanted to burn low cost, high density (1010 kg/m5) fuels in your diesel engines you were out of luck. Because the separator on your vessel could only handle fuels with densities up to 991 kg/m.' The only system that can separate fuels with a density greater than 1. Introducing the ALCAP" system: the only fuel oil separa- tion system specifically designed and proven to clean fuel with densities as high as 1010 kg/m5 at 15°C. An ALCAP system will give you the choice of burning low cost, heavy fuels. And it will allow you to save between $2 and $5 per ton of fuel. 990 TO 1010 WITHOUT ADJUSTMENTS. The ALCAP system has a new model FOPX separator that works without gravity discs. You don't need to change discs to accommodate variances in density, viscosity, temperature and flow rate. A single, per- manent flow-control disc does the job. The innovative ALCAP design gives you continuous, trouble-free operation and opti- mum separation, no matter what grade of heavy fuel oil you're burning. RETROFIT YOUR SEPARATOR AND SAVE. If your present separator is an Alfa-LavaFWHPX model, we can convert it to an ALCAP system and save you money. The system is available in stan- dard modules, pre-assembled, pre-wired, and ready to install. So you benefit from Alfa-Laval's design expertise, as well as our worldwide service. ALCAP systems are fully tested and are already saving money on board ocean-going vessels. For information on our complete line of purification and separation equipment con- tact Alfa-Laval, Inc., Marine Division, P.O. Box 1316,2115 Linwood Avenue, Air Fort Lee, NJ 07024. ^SW Tel: (201) 592-7800. Free 28-page guide. Circle number on reply card. OC ALFA-LAVAL Circle 103 on Reader Service Card
