View non-flash version
Silver Knight Award For Carl R. Meurk Of Todd Carl R. Meurk Carl R. Meurk, executive vice president of Todd Pacific Ship- yards, was the recipient of the National Management Associa- tion's Silver Knight award in the NMA Todd Seattle Chapter's spe- cial presentation recently at the Tyee Yacht Club. The Silver Knight of Manage- ment is the highest award the NMA chapters can give an out- standing executive. This is the first major award that Todd Se- attle Chapter, now in its third year, has bestowed on one of its own members. The Seattle Chapter nominated Mr. Meurk for his outstanding contribution to the company and the shipbuilding industry for more than 30 years. Mr. Meurk, who is also vice president-West Coast of Todd Shipyards Corpo- ration, has been associated with Todd Seattle for 22 of his 33 years with Todd. $6-Million Navy Order For Gas Turbine Recovery System Solar Turbines Incorporated, San Diego, Calif., has been award- ed a $6,379,779 cost plus award fee contract for development of a gas turbine waste heat recov- ery system for use as a high ef- ficiency cruise propulsion plant on non-nuclear combatants. The Naval Sea Systems Command is the contracting activity. (N00024- 81-C-5340) Great Lakes Transportation Publication Available An inventory of American com- mercial shipping vessels used in ocean trade and on inland water- ways is compiled and published annually in a three-part series by the Waterborne Commerce Sta- tistics Center of the U.S. Army Corps of Engineers' Water Re- sources Support Center. The center announced recently that the 28-page 1980 edition of Transportation Series 3, "Trans- portation Lines on the Great Lakes System," is available and may be purchased for $1 from the New Orleans Engineer Dis- trict, LMNED-S, P.O. Box 60267, New Orleans, La. 70160. Other parts of the series will become available in the near future. Publish Literature On Stern Tube Lubrication System From Waukesha Literature describing the com- pany's automatic Circoolmatic oil circulation and cooling system for stern tube seal lubrication has been published by Waukesha Bearings Corporation, Waukesha, Wis. The system is recommended for 710 mm seal systems and larger. Circoolmatic pumps oil from the forward seal through a sea-or- freshwater cooling system, pro- viding maximum lubrication. Oil may also be used as a coolant and may be pumped from the mainstern tube bearing sump into the cooling coil, then into the main head tank. The Circoolmatic is a flooded circulating type system, with the seals, reservoir, and circulating pump fitted and primed at all times to maintain seal oil at a satisfactory cooling level. Stand- ard features included are a fail- safe alarm system; pilot lights indicating proper pump operation and adequate oil level; and an audible alarm that signals low oil level. For a free copy of the litera- ture on the Waukesha Circool- matic system, Write 14 on Reader Service Card BUTTERWORTH SFC BW separators feature a permanent filter bed (no dirty cartridges to change, no messy disposal). Automatic operation without attendance is available. U.S. Coast Guard approved. Special Filtering Material. One outstanding feature of SFC BW (Separator Filter Coalescer Bilge Water) Oil/Water Separators is the permanent final filter bed Composed of specially treated oleophilic particles, it can be used over and over again. With heavy use, an annual topping of 5% to 15% is the only filter bed maintenance required. Moreover, treated water discharges are typically less than 2 parts per million of oil... well below the maximum allowable 15 parts per million. Unattended Operation with Automatic Option. Because of the permanent final filter bed, SFC BW Separators ordered with the automatic option can operate unattended for weeks at a time. Whenever the filter bed reaches a pre-set degree of oil saturation, a very accurate vacuum-operated controller stops separation, initiates a cleansing back-flush cycle and sounds an alarm. After back-flushing, separation Automatic valve provides total "hands-off" operation. automatically starts again. The 20-minute back-flush cycle occurs only once every 12 to 24 hours of operation, depending upon oil concentration. Unique Compact Design. Because of the permanent filter bed, which requires only limited access annually, SFC BW units are very compact. All processing takes place in a single vertical cylinder requiring a minimum of deck space. A 2 cubic meter per hour unit, for example, is only 2 feet in diameter. Every SFC BW unit is equipped with its own pumps designed to meet a vessel's needs.They do not rely on existing bilge pumps. U.S.C.G. Approved. In U.S. Coast Guard certification tests, BUTTERWORTHK SFC BW Oil/Water Separators exceeded U.S.C.G. and IMCO A.393(X) requirements. SFC BW Oil/Water Separators have also been approved in conformance with A.393(X) by France, Germany, Greece, Italy, Netherlands, Norway, Poland, Sweden, United Kingdom, and Yugoslavia. Get All the Facts. SFC BW Oil/Water Separators are available with capacities from Vz to 10 cubic meters per hour. Write or call for full details.. .and for a copy of "From A to X about OilV Water Separators". This six-page report has facts on MARPOL, IMCO, and U.S. regulations for shipboard oil/water separators. Butterworth Systems BUTTERWORTH SYSTEMS INC. 224 Park Avenue, Box 352 Florham Park, N.J. 07932,USA Telephone: (201) 765-1546 Cable: BUTTWORTH NEW YORK Telex: 136434 BUTTERWORTH SYSTEMS (UK) LTD. Croydon CR9 4NX, England Telephone: 01-684-4049 Cable: MAROPEDOK CROYDON Telex: 946524 In Continental Europe, contact: Societe d'Etudes et de Realisations d'Equipements Petroiiers 11, rue du Pont V 76600 LeHaure, France Phone: (35) 25.81.15 Telex: Sotran 190571 F Oil/water separation made simple Chemically treated oleophilic particles are used for the exclusive integral, permanent filter bed. November 1, 1981 t Copyright 1981, Butterworth Systems Inc. Write 1411 on Reader Service Card 43
